My Child Floe Convertible Pushchair Manual do Utilizador

Floe Infant CarrierFor the Floe Convertible PushchairV2INSTRUCTIONS: PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. YOUR CHILD’S SAFETY MAY BE A

page 9Fitting the harnessPress the belt adjuster button and pull on the shoulder harness straps to create slack. Press the red release button (A), unb

page 10Buckle up the harness. Connect the two shoulder strap connectors (B) and insert into the buckle (C). Ensure harness buckle is rmly clicked int

page 11The harness should allow 1 nger-width (1cm) of space at the top of the shoulders. This is the ideal tightness. Note: Check that the buckle is

page 12Take the diagonal belt around the back of the child car seat and slot it into the rear seat belt guide (C). Thread the section of diaganol belt

page 13To remove the hood: press the small tabs (A) on each side of the child car seat and slide the plastic stay out from the socket.To re-attach the

page 14Removing the seat coverThe seat cover is held in place with plastic clips at points 1, 2 & 3 on each side of the child car seat.Slide the p

page 15Attaching the seat to the chassisRemoving the seat from the chassisNote: The car seat can only be tted parent facing (as shown).Hold the car s

page 16Care and maintenance1) Store this child car seat in a safe place when not in use.2) DO NOT place heavy objects on top of it.3) Always store the

page 1Safety adviceWARNING: The correct tting of the vehicle seatbelt (following the guide markings) is of vital importance for the safety of your ch

[email protected] by MyChild. M34 3QAwww.mychild.co.ukTel: 0161 335 2508

page 2Vehicle seat travelling adviceIn order to maximise the protection that the child car seat can give your child, please adjust the harness so that

page 3WelcomeThank you for purchasing the Floe 0+ Car Seat.Please read the instructions and warnings carefully before use to ensure safe and satisfact

page 4 1 Carry handle2 Shoulder pads3 Harness buckle4 Harness adjuster button (under seat cover)5 Harness adjuster strap6 Insert cushion7 Shoulder str

page 5Front passenger seat (no active airbag)YesFront passenger seat (active airbag)NO2-point seatbelt NO3-point seatbelt YesBack left & right sea

page 6The carry handle has 3 positions.(1) Feeding/non-rocking position. (2) Rocking position.(3) Carrying position: Make sure handle is locked bef

page 7Adjusting the shoulder harness height (continued)Press the belt adjuster button and pull on the shoulder harness straps to create slack. Press t

page 8Buckle up the harness. Connect the two shoulder strap connectors (D) and insert into the buckle (E). Ensure harness buckle is rmly clicked into